i read about the 'gap'
and i think it is to ensure adequate
spacing between the throwout bearing and pressure plate fingers.
but not sure quite where the feeler gauge goes?
also, here is the equalizer bar frame bracket.
is the pivot pin pressed on
or is the outer end flattened down to hold it in?
is it supposed to rotate?
if not i'll have to put a spot of weld on it to hold it firm?
iowa
[Blocked Image: http://www.surfacezero.com/g503/data/500/medium/2011_02_12_023_eq_bar_frame_bracket.jpg]