- Official Post
Here is an Ebay auction for an NOS C2OZ 6564 A rocker arm by Ebay member "machviii" with a Buy-It-Now of $29.99:
This auction is for C2OZ-6564-A NOS Rocker Arms. A quantity of ONE will receive ONE rocker arm. At the start of this listing I have 5 available. They are ALL new NOS Ford, but packaging may vary slightly from one to the next and picture is representative of what I have. I have bought and sold close to one hundred of these in the past few years and they have become VERY rare. Don't wait until you can find a full set, buy them up before I do.
These rocker arms are NOT the rail type rockers that were used in the common 289 to keep the pushrod in its place. These rocker arms are the higher performance type that required screw in studs and guideplates to keep everything aligned. These may have been used on some of the early 221, 260, 289 based on the information in the parts manuals until they switched to the cheaper style. I have had a few sets up these in the past and they sell VERY quickly. These are 100% correct for the 289 HiPo engine as used on 64-67 Fairlanes and 65-67 Mustangs. There is also a listing of an additional year with the HiPo motor for 68 Torinos and Mustangs, but I do not recall hearing of the 289HP available when the 302 was introduced. Please check the fitment description listed below and check your own sources.
The part number is C2OZ-6564-A .
62-64 Ford full size, Fairlane, Falcon 221,260;
63-64 Ford full size, Fairlane, Falcon (2V) 289;
63-64 Fairlane 4V 289 HiPo
65-66 ALL W/ 260,289 (BEFORE CHG/L11)
65-67 289 HiPo
65-68 HIGH PERF, Fairlane, Torino, Mustang 289 (USE W/ HYDRAULIC CAM & 351W HEADS)
https://www.ebay.com/itm/3825293554…e=STRK:MEWAX:IT
-Fred-