Posts by C6ZZKGT

    This NOS C7ZZ 15520 A backup light switch that was "no longer available" is back on Ebay again with the same Buy-It-Now of $200.00:

    NOS 67 68 Mustang 289 390 Cougar 4 speed Back up Lamp Switch C7ZZ-15520-A | eBay

    -Fred-

    The listing for this NOS C7ZZ 15520 A backup light switch was ended by the seller February 20, 2025 with the following explanation "this item is no longer available".

    -Fred-

    This NOS C5ZZ 7A533 A upper clutch rod at firewall boot that was "no longer available" is back on Ebay again with the same Buy-It-Now of $55.00:

    NOS 66 Mustang Clutch Pedal Rod Seal C6ZZ-7A533-A | eBay

    -Fred-

    The listing for this NOS C5ZZ 7A533 A upper clutch rod at firewall boot was ended by the seller February 20, 2025 with the following explanation "This listing was ended by the seller because the item is no longer available".

    -Fred-

    Here is an Ebay auction for a used C5DA bellhousing by Ebay member "mrracing" with a Buy-It-Now of $175.00 or make offer:

    Factory original for a 1965 1966 or 1967 289 302 cu.in. 6 bolt Ford Mustang and 1965-1968 Ford 289 6 bolt applications - OEM 6 bolt aluminum 4 speed bellhousing – takes 157 tooth flywheel – Casting number C5DA-6394-A with date code as shown – Bare bell has been cleaned up in “as found” condition as shown – threads in great shape – blasted with natural unpainted finish shown – bare bell as shown – this bell is blemished with several issues as shown – one chip out of one side dowel pin hole from rough handling – one lower dust shield boss is chipped off as well – face of bell had the 1964 and older Toploader pattern drilled in it as well – inside edge of the bearing retainer had several spots that had set screw holes as shown for some unknown reason – structurally rings fine and is in usable condition – please view all cracks/chips/blemishes in the pictures

    1965-1968 Ford Mustang 289 302 Falcon 4 Speed Bell Housing C5DA-6394-A Cracked | eBay

    -Fred-

    This used C5DA bellhousing sold February 19, 2025 on Ebay for $175.00.

    -Fred-

    This used Weber setup and intake intake manifold sold February 19, 2025 on Ebay for $3,950.00.

    -Fred-

    Here is another Ebay auction for an NOS C5ZZ 10838 B 65/66 Mustang woodgrain instrument cluster bezel by Ebay member "Garage Classics 1" with a Buy-It-Now of $170.00 or make offer:

    Garage Classics is proud to offer you

    a factory Ford dash bezel

    Part # C5ZZ-10838-B

    Woodgrain dash

    NOS and ready for install

    Please check part number for exact fitment

    Part is on excellent NOS condition

    1965-1966 Mustang

    Please see all pictures!

    In stock and ready to ship!

    65-66 Mustang NOS Instrument Panel Bezel Woodgrain C5ZZ-10838-B | eBay

    -Fred-

    This NOS C5ZZ 10838 B 65/66 Mustang woodgrain instrument cluster bezel sold February 19, 2025 on Ebay for $153.00.

    -Fred-

    Here is an Ebay auction for a used set of Boss 302 rods by Ebay member "qrtrhrse1965" with a starting bid of $500.00:

    I have a full set of 1970 Boss 302 connecting rods. I had two sets that came with a Boss 302 engine that I purchased. My machinist decided to use the other set since it was already drilled out for floating pins. He said that these were still good. They have been reconditioned and previously balanced. Please see the pictures for condition or if you have questions or need additional photos let me know.

    1970 Boss 302 Connecting Rods Hipo 289 C3AE Complete Set | eBay

    -Fred-

    This used set of 8 Boss 302 rods sold February 19, 2025 on Ebay for $500.00.

    -Fred-

    This pair of NOS C5ZZ 16228 B Hipo fender emblem is back on Ebay again with the same starting bid of $100.00:

    1965-66 NOS Mustang High Performance Fender Badges | eBay

    -Fred-

    This pair of NOS C5ZZ 16228 B Hipo fender emblems received no bids by February 20, 2025 and therefore did NOT sell.

    -Fred-

    This 66 Mustang GT fastback that appears to be Signal Flare Red with Red pony interior that was "no longer available" is back on Ebay again as a Buy-It-Now with the same price of $119,000.00 or make offer:

    1966 Ford Mustang Hi-Po 289ci/271hp | eBay

    -Fred-

    The listing for this 66 Mustang GT fastback that appears to be Signal Flare Red with Red pony interior was ended by the seller February 22, 2025 with the following explanation "This listing was ended by the seller because the item is no longer available".

    -Fred-

    Are they good for a 1964 December kcode engine ?

    I don’t see the piston oiler?

    Not all Hipo 289 rods have the piston oiler that you mention. Originally, the Hipo 289 rods were press fit to the pin. The conversion of these rods to full floating has already been done and cannot be undone. These are also steel to steel floaters, which are less expensive to do compared to ones that are done with bushings. My issue with rods that were converted is that the retainer grooves for the pin retainers need to be machined in the pistons if they do not have those grooves. I have seen too many piston pin retainers come loose and score the cylinder. Press fit pins can sometimes move as well but in my observations, not that often. Therefore all of the Hipo 289 rods that I stock are press fit. I have ones that I purchased in error that were floated but I won't use them. Every once in a while someone will need one or more of these floated rods. The big ends of these rods have been maxed out on the balance weights. . I am sure my comments here may be controversial, but these are all lessons that have all been bought and paid for with experience. Your milage may vary.

    -Fred-

    Here is an Ebay auction for an NOS C3OZ 6A360 A counterweight and NOS C3OZ 6306 A crank sprocket by Ebay member "bobmannel" with a starting bid of $200.00:

    Offering as a combination set. 289 HiPo NOS C3OZ-6306-A crankshaft sprocket with roll pin and NOS C3OZ-6A360-A HiPo counterweight, commonly call "hatchet". Box and envelope included. Never used, just has shelf wear. What you see is what you get. These have not been media blasted or wire wheeled. They are natural as they came out of the packing. I did install the roll pin in the sprocket.

    NOS 289 HiPo C3OZ-6306-A crankshaft sprocket C3OZ-6A360-A hatchet counterweight | eBay

    -Fred-

    This 66 Mustang GT fastback that appears to be Signal Flare Red with Red pony interior is back on Ebay again as a Classified ad with the same price of $119,000.00 or make offer:

    1966 Ford Mustang Hi-Po 289ci/271hp | eBay

    -Fred-

    This 66 Mustang GT fastback that appears to be Signal Flare Red with Red pony interior received no bids by February 19, 2025 and therefore did NOT sell.

    -Fred-

    Here is an Ebay auction for an NOS B7A 12106 A FoMoCo distributor cap and B7A 12200 A Autolite rotor by Ebay member "sheltielola92127" with a Buy-It-Now of $900.00 or make offer:

    NOS Ford-Autolite Distributor Cap and Rotor DH-6 and DR-5 NIB

    Part No. is B7A-12106-A , B7A-12200-A DH-6 and DR-5

    This cap and Rotor was made between 1957-1965 Perfect for your early "HiPo" 289, "K" Code Mustang, Shelby GT-350, Cobra, Sprint, Falcon, "427" FE, and "Y" Blocks

    Honestly its Beautiful, I speak frankly for its age and never open/ installed or touched. Definitely a cool factor.

    NOS Autolite Distributor & Rotor Cap DH-6 DR-5 HiPo 289 K Code Mustang Shelby | eBay

    -Fred-