The seller just cancelled the listing.
-Fred-
The seller just cancelled the listing.
-Fred-
I do not see a hole in the firewall for the choke cable. I have questioned the seller on the coupe VIN. It may be an interesting answer if they respond.
-Fred-
I also have a C3AE 6015 N block and it is definitely a Hipo.
-Fred-
There is really not much in the way of "K" stuff left. Possibly the front springs and sway bar seem to be about it. There is a picture of the air cable which I am sure that the seller thought was the choke cable, so the choke cable seems to be gone as well. At least the apron VIN stamps are there.
-Fred-
It is always good to hear when a retailer steps up and takes care of customer problems correctly especially when they did not create the problem.
-Fred-
There would not be an early date code 66 Hipo head setup for emissions so these most likely are standard heads.
-Fred-
The tail shaft bushing part number is B3TZ 7A034 A which is replaced with a B3TZ 7A034 B and is a package of two. The front seal is a B7AZ 7A283 A which may be replaced with a D8UZ 7A283 B package of two. I am unsure of the front seal replacememnt as it does not show in my O.S.I. books but is a reasonable guess. The front seal also comes in the E2ZZ 7153 A gasket set. I have a lot of B7AZ 7A283 A front seals in stock.
-Fred-
For something that has been sitting in a warehouse for so many years, the decals at the rear look like they have seen some heat or sun as they look really aged, especially the spark plug one.
-Fred-
It has the later 66 style motor mounts. Makes you wonder what other items have been compromised. At this price there should be no issues. A better painting job could have been done on the inner apron by the VIN at least. It looks like it was just painted over a couple of times with minimal or no attempt at sanding to blend the previous paint. It would seem to me that with the fuel filter on the fuel pump in 65 that there would be no reason to cut the fuel line to the carb and add another filter. It just adds to the lower quality of some of the details on this Kar.
-Fred-
That may be a Corvette generator with the tach drive.
-Fred-
Johns Mustang has them for $64.95 providing that it is steel and not aluminum.
-Fred-
I had a 289 Hipo that I ran on the street with a C4 and found that with 3.50 gears all that needed upgrading was a higher stall converter.
-Fred-
I have your original block. This needs to replace my original post on this topic as I made a mistake in typing the VIN the first time.
-Fred-
The dealer is doing their best to inflate the price by keeping it at the unrealistic price they had before.
-Fred-
The correct NOS one with CARbureTER on the side just sold for $925.00 on Feb 19. It was on Ebay auction number 370022498861.
-Fred-
I still have the set that we spoke of earlier.
-Fred-
I also sent you a PM, Jim.
-Fred-
I just resent the information in an email Jim. Please let me know if you receive it.
-Fred-
At least the seller this time around is trying to be honest about the added GT package. It has now been on both coasts and has less than 500 miles added since the last time around.
-Fred-
I have seen on Ebay one instance where a C5ZZ 17360 A box was displayed with an 8,000 RPM unit but I would not vouch for it being originally in that box. I just sent the seller an email on this one encouraging them to really check what they have.
-Fred-