It looks like you did a great job in being able to trace your Kars history all the way back. I am sure that few people, with so many owners of a car, have been so fortunate.
-Fred-
It looks like you did a great job in being able to trace your Kars history all the way back. I am sure that few people, with so many owners of a car, have been so fortunate.
-Fred-
The Ebay auction was withdrawn by the seller. Did you get this Kar, Duncan?
-Fred-
The archives sure are a help when researching a Kar on this forum!!
-Fred-
This is an addition to Charlies post as he put his up just before I did this one and this is just another way to explain it. The fact that it has a bolt on snubber and the shape of the housing makes it a 9 inch for sure. The easy way to tell without any measuring, or even being able to see in the dark, is to check the lowest retaining nuts for the third member. If you cannot get a deep 9/16" socket on the nut, then it is a 9 inch. The reason that you would not be able to get the socket on is that the 9 inch pinion casting sticks down far enough to interfere with the socket. The 8 inch is a straight shot.
-Fred-
K codes were never stock with a supercharger. I could not find anywhere in the auction where the seller stated that this was stock. This Kar is already being discussed under the Kars forum.
http://www.hipomustang.com/hpmx/topic.asp?TOPIC_ID=8813
-Fred-
Dave, I stand corrected on this as I failed to notice the "reserve not met". I need to open my eyes more in the early morning hours when I read the auction!! I am deleting my previous post on this.
-Fred-
Mark, I sent you an email on this.
-Fred-
A vinyl top can be removed and you would normally leave the divider moldings on the roof at the quarter. This is also the time when you will get your rust surprise especially around the rear window.
-Fred-
Be careful about drilling through the carpet as it will wind up getting stuck to the drill bit and shredding the carpet. I use a long awl and just punch small holes into the tunnel for the screws with a hammer. Be careful when putting in the screws as they can also shred the carpet.
-Fred-
To comtinue further on Daves comments, the vinyl top can be a negative due to the rust issues surrounding them.
-Fred-
The 9" refers to the outer diameter on the ring gear. Some of the early 9" gears actually measure 8 3/4".
-Fred-
Very good looking Kar!! Very unusual to be equipped for appearance and performance and then not equipped with creature comforts the way it is.
-Fred-
Kar sold on Ebay for $25,000.
-Fred-
Kenyon, is the hospital planning to do another raffle like this next year?
-Fred-
Tim, What number 65 carb do you need? I may be interested in a trade.
-Fred-
Tim, A friend of mine has the exhaust manifold. He also has an original fan with a 66 date. You may contact me if you are interested.
-Fred-
I am happy that much needed funds were raised with this raffle. I know that is is especially tough in these current times to get anyone to part with any of their funds.
-Fred-