Tom, I have sent you both an email and a PM on this carburetor.
-Fred-
Tom, I have sent you both an email and a PM on this carburetor.
-Fred-
The glove box door is a standard 66 unit with an added woodgrain insert in the center. The 4 way flasher switch is not in the glove box but rather under the dash above the accelerator pedal.
-Fred-
This one has been discussed here previously:
http://www.hipomustang.com/hpmx/topic.asp…rms=5F08K259311
-Fred-
Spencer, Would it be possible to please post the selling price so that the board can get a sense of where the market is now?
-Fred-
This looks correct to me. As Charles Turner has repeatedly said, the date code is purely a scheduled date. It is not unreasonable for your Kar to have an engine produced after the scheduled date as Hipo engines were not produced in the mass quantities of the standard engines.
-Fred-
Back on Ebay again. The starting bid price is unchanged however the Buy-It-Now price has been raised from $26,500 to $27,500.
http://cgi.ebay.com/ebaymotors/ws/…K%3AMEWAX%3AVRI
-Fred-
The Ford MPC lists the changeover date as from 2/14/66. Ralph, the reason that the standard Z/Bar that you bought from Ford did not have the hole is because it was actually a 65 part number that was still available at the time. The part number is a C5ZZ 7528 E and the only difference from the early 66 one is that the upper swivel for 65 is on the bar. The way to use it on your 66 is to remove the swivel. The part number for the Hipo Z/Bar from 2/14/66 is a C6ZZ 7528 E. The earlier one is a C6ZZ 7528 B.
-Fred-
Looks very good, Quentin.
-Fred-
Welcome to the forum, Bryan.
-Fred-
Thanks for the clarification on the top bar, Dave. From all of the information up to this point I also thought that it was the "Quincke" tube.
-Fred-
Thanks for the update, Robert.
-Fred-
Great looking Kar, Spencer!!
-Fred-
Jeff, How was it determined to be a rebody? Enquiring minds want to know. ![]()
-Fred-
A correct pump casting for the 65, 65 and 67 vintage will be CARbureTER and not CARTER.
-Fred-
This Kar sold for $14,605 on June 28,2009 on Ebay.
-Fred-
Keep in mind that this lever with the extra external spring lever cannot be used with the internal spring. The place where the spring normally sits has a dimple to locate the internal spring. This lever is slotted where the dimple was to locate the external spring lever.
-Fred-
Jeff, The Kars that I saw with two rubber bumpers were both Metucheon units.
-Fred-
Mark, The rubber bumper bolted to the upper body plate with two bolts is incorrect. That is the 8 inch style. The rubber bumper should only be the C3AA square pyramid shaped bumper with one stud bolted to the axle snubber.
-Fred-
I have personally inspected two 66 models that had rubber bumpers bolted both to the body plate and to the rear end plate. It was really an interferance and incorrect to have both but I have heard of others like this as well. My guess would be that it was an assembly line error as the body plate is setup for the upper rubber bumper. An assembly line worker could easily make an error on this being as the K codes were so uncommon.
-Fred-