Posts by C6ZZKGT
-
-
This Kar is also being discussed at this link:
http://www.hipomustang.com/hpmx/topic.asp?TOPIC_ID=9054
-Fred-
-
This C3OF-AJ carb directly above also has a manual over ride kit for the secondaries.
-Fred-
-
Keep in mind that the mounts listed directly above are for Fairlanes. Only some of the pieces fit Mustangs.
-Fred-
-
The seller lists the tail shaft on the HEH-T as a C6OR 7A040 which is virtually the same as the C7OR 7A040 A shown in the pictures with the RUG-M transmission. Neither one is correct nor will work for a 65 Mustang. The HEH-T trans also takes a different tail shaft than even an HEH-BX trans.
-Fred-
-
This HEH-T trans has the wrong tailhousing which is setup with the wrong trans mount boss and the wrong shifter location. It is also possible that it is no longer a close ratio.
-Fred-
-
-
Adison, I just sent you an email.
-Fred-
-
Tom, Welcome to the forum.
-Fred-
-
Sold again for $1,300.
-Fred-
-
He will be really handy for getting at the tight spots underneath the car.

-Fred-
-
Last sale fell through so it is back on Ebay again:
-
Relisted again with a $2,990 reduction in price. It is now listed at $67,000 AU or make offer.
-Fred-
-
Steve, that crossmember is for a later car and will not work for you. The correct one has a bracket for the parking brake attached to it. I have a really nice used one available. Please send me a PM if you need it.
-Fred-
-
Walter, you can convert your gearbox to a close ratio however it is better to sell yours as at least it is still good. In order to change it over you will need a cluster, input shaft, second and third gears. That plus the time to change it over can be expensive. Of course you will still have the incorrect tag so everyone will think that the box is still a wide ratio and incorrect. You will also end up a set of less desirable wide ratio gears left over.
-Fred-
-
I certainly think that Charles will respond to this request.

-Fred-
-
Walter, I just sent you a PM on this.
-Fred-
-
Walter, the Ford parts book shows the same information that you are quoting and up until a couple of years ago that was deemed to be gospel. Information has recently surfaced through this forum of Kars built far after the changeover date which still have HEH-T transmissions. These are Kars with VIN stamped cases which gives them high credibility. I truly believe that Ford made a mistake in the book and really meant the dates to be as planned but ended up with too many HEH-T transmissions left over and just kept putting them in Kars. The only real difference other than the tag is the tail housing as the HEH-T has a C4DR housing with the extra mounting bosses for a Falcon shifter. The rear two Falcon shifter bosses are cut off to clear the Mustang linkage and therefore can not be used for a Falcon. The HEH-BX has a C4ZR tail housing that does not have the Falcon shifter mouting bosses. You will still need an HEH-T trans.
-Fred-
-
Gary, I just sent you an email on this.
-Fred-
-
Jim, another post regarding the tube dimensions was made by Don and the link is below:
http://www.hipomustang.com/hpmx/topic.asp?TOPIC_ID=8992
-Fred-