Terry, They gave your model a convertible chassis. ![]()
-Fred-
Terry, They gave your model a convertible chassis. ![]()
-Fred-
Your handle of RALLY is still registered to you on this forum. Maybe you forgot your password?
-Fred-
Joe, I sent you an email on this.
-Fred-
67 is a different moulding than 65/66.
-Fred-
Doug, So where did you find your bolts?
-Fred-
Back on Ebay again with a Buy-It-Now of $6,850.
http://cgi.ebay.com/ebaymotors/ws/…3AVRI&viewitem=
-Fred-
Relisted on Ebay again. Buy-it-now lowered to $44,500:
High bid this time around was $30k
http://cgi.ebay.com/ebaymotors/ws/…3AVRI&viewitem=
-Fred-
Rally Pacs are not standard equipment but rather an extra cost option. They could be factory installed, dealer installed or bought over the counter and installed by the customer.
-Fred-
The C5ZZ 5230 S and C5ZZ 5230 R are listed as replacements for the Arvinode system. They were also listed as a muffler only replacement for the more complete muffler and resonator assembly until Ford decided that the assembly was all that they would service. I do not believe that the mufflers in the auction are really represented as originals but just the correct type for the time frame. Ford would have seviced these for a couple of years.
-Fred-
Here is an NOS 65 muffler system for cars produced after 10/15/64. This must be the non-Arvinode version that was used when people complained about the noise. This is only $8,500.
http://cgi.ebay.com/ebaymotors/ws/…22330&viewitem=
-Fred-
Jason, Thank you for your interest. I just sent you a PM with all of the information.
-Fred-
Mike, I sent you a PM on this.
-Fred-
Chris, according to Daves post and pictures above, it would appear that the hangers are already available from NPD.
-Fred-
The shifter must be the valuable part of this deal. ![]()
-Fred-
It would depend a lot on whether it is standard bore size and general overall condition. Are you trying to buy or sell?
-Fred-
Rick,
Send me some pictures of it and I will figure it out for you. Some of your stamped numbers do not make sense.
-Fred-
This Kar has C8ZE replacement Hipo heads.
-Fred-
I have had this same problem with original exhaust manifolds more than once. This is fixed, as Charles says, by loosening and holding the exhaust manifolds up while tightening them back down. I even have some really thin wall sockets that will not fit when the manifolds are too low. The interference is with casting flash and it is not always the same on all manifolds.
-Fred-
Dave, The Mustang lists a 15 X 5 1/2" and it is a C1AZ 1007 A. That wheel was used from 61-64 on some full size Fords and 65 full size Ford taxicabs. The 15 X 6" is a C5AZ 1007 B. This was listed for a 65 full size Ford with a 427. That number was replaced by a C8AZ 1007 F which would be an incorrect style.
-Fred-