One problem with the repro main caps is that they did not make the rear cap. The rear cap is different from a standard cap as well.
-Fred-
One problem with the repro main caps is that they did not make the rear cap. The rear cap is different from a standard cap as well.
-Fred-
This Kar sold for $1,520 on Ebay on October 15, 2009.
-Fred-
It is always good to hear positive input regarding vendors.
-Fred-
I logged in last night without a problem.
-Fred-
Charles, I second that opinion as well!! By the way I am sure that Alex meant to say "unselfishly".
-Fred-
Don, I withdrew my post.
-Fred-
For everyone that has already sent your fuel pumps in for this run, thank you very much. For all of you that are thinking about sending yours in, I am establishing a cutoff date of November 2, 2009. My objective is to have this run completed by the end of November.
-Fred-
Welcome aboard, Korbi. You will find many helpful and enthusiastic people on this forum.
-Fred-
This Kar has Hipo heads and a standard block. It has an AFB carb rather than the correct Autolite.
-Fred-
The diameter is .278 which is approximately 1/4".
-Fred-
Interesting wheel opening moldings!!
-Fred-
It just occurred to me that you are looking for the boot and for some reason I was thinking of the cap gasket. If you still need a boot that goes on the end with the push rod, I do have one.
-Fred-
This Kar sold on Ebay on October 11, 2009 for $25,000.
-Fred-
The only other car that the Hipo mounts will fit as they are made are 63-65 Falcons and Comets.
-Fred-
Bob, For as long as they have been trying to sell this Kar, a $20,000 offer just might fly. I believe that they are probably into it close to that. That particular dealer is more into English cars but dabbles some in American cars. I have been to their place to do an inspection on another Hipo Kar that they were selling last year. From what I have seen in the pictures, a thorough inspection should be done before making a firm offer. At the very least the offer should be made pending an inspection. I can be available for an inspection if you decide to go that way.
-Fred-
Dave, You are correct that there is no specific listing for 65 and 66 GT350 in the MPC and I have only been able to go by what has previously been found on original cars. So far they have all been the 15/16" which, as you stated, are Fairlane wagon which was the source for the rest of the rear brakes. The MPC does not really list rear wheel cylinders very well as you are required to know the size before ordering one. The listing is very vague and especially on 6 cylinder cars. The Fairlane listings are equally vague and are only by size and not application regardless of engine size or body style. As a Ford parts manager, I just had to know from experience. Keep in mind that generally the wheel cylinder rubber cups have the size cast into them.
-Fred-
The "B" suffix is a 29/32" cylinder. If the article listed the "A" suffix as a 29/32" cylinder, the article is incorrect. The "A" suffix is definitely a 15/16" cylinder.
-Fred-
I would be curious as to whether the left front inner fender apron has been replaced on this Kar. The stars on either side of the VIN are crooked and slightly oversize, the VIN is in an odd area and the characters in the VIN are spaced too closely.
-Fred-