I just put the console back into my 66 fastback the bracket was long gone, i purchased a new Scott Drake bracket mounted it to the bare floor, slit theunderpad and carpet, no problems with te install.
Posts by bob 66_old
-
-
I would like to re-woodgrain the console in my 66,I have the original metal backing which could be re-covered. I purchased a woodgrain kit from NPD and most of the die cut pieces were too short. I did some searches on the net and found a couple of sites.1) Tony's Auto Classic, they sell the woodgrain kits with the metal back 2) Auto Mega, which sells 3M Di-Noc adheive backed woodgrain in 2ft wide sheets. 2'x 4' $80.00
Has anyone used Tony's product and how much is the cost and is rosewood flat matt the correct wood grain and lastly what adhesive to use the bond he metal plates to the console.
Thanks, Bob 66
-
Thanks, I will be there on Thursday
-
I am planing on going to the Ford Nationals in Carlisle Pa next month,I was wondering if the swap meet is open on the Thursday? I have attended the Corvette show at Carlisle and found that Thursday was the best swap meet day.
Thanks Bob 66
-
Hi Bob;
Looking forward to attending the meet and I'll look you up
Bob
-
Hi Bob,This will be my first time attending this event,5 hour drive from Chatham Ontario. what's your booth #. Bob Moon
-
Hi Eric; I sent you a PM
-
Thanks;
I'll look for a number on it tonight
-
My 66 K code has a stamped steel alternator bracket,is this correct?or should it be a cast iron type?
Thanks, Bob
-
can someone tell me the correct casting # for a 1966 drum brake non power master cylinder and what bore size should it be? Thanks, Bob Moon
-
Been reading some of the old posts on the proper pinion snubber brackets and my 66 march 65 build car has the boss big block later style snubber, I am not quite clear on the post as to which one would be the correct snubber for my car ( 65 type or 66 type) and where is the 2-5/8 " measurement taken from? Thanks Bob Moon
-
Thanks Jim; I'll pick those up @ NPD
-
Can anyone help me out here, In the NPD catalogue they don't show either a weld and sealant assembly manual or a chassis assembly manual aailable available for a 1966 mustang. I went onto the osbourne reproduction website nad they don't show them available either. can anyone tell me where to purchase them or do you resort to using the 1965 manuals. thanks, Bob Moon
-
Can you give me the casting #'s and dates on your HI-PO exhaust manifolds Thanks Bob Moon
-
Hi Bob; Can you send me a few photos I googled Autolite carburators couldn't find out what the actual date B5JD is, do you have this info. Thanks Bob Moon