Posts by seisei_old

Thank you jwc66k for the pics that you sent. I have check ball in there.Is it possible that fuel comes through the secondary throttle control vacuum tube when I let gas pedal up fast.

I was test drive and after that shut the engine and open carburetor and check floats.pri and sec are both 26/32...few minutes and i notice that fuel is boiling....after that i open secondary cover and there comes a lot of fuel inside the cover where the spring is.Can this be due to carburetor settings?

I put new top gasket before test drive..If I do hard acceleration, so I smell fuel..

I notice that when I screws top back...gasket was wet..

Edited by - seisei on 07/19/2011 03:50:48

Edited by - seisei on 07/19/2011 05:07:35

Outer cover was wet on the down of the cover. What check ball?Where it is?What that ball do?

I open secondaries diaphragm and there was fuel inside.where the fuel comes here?I open carburetors top and check the fuel float. fuel height is 1" from the top .motor is not used for two days

here is the tool which i checked secondary..

[Blocked Image: https://lh3.googleusercontent.com/ClekoySJEUvJFYQbZxCiGZKP6KR0-ANWL69Fqlm5rspRWb9wGICx7PYbL09AJUIABehtIEjexb27aidccR1ORDsCsg]

[Blocked Image: https://lh6.googleusercontent.com/oyZGn_Ac8bC23L4hRjYC6BXHFyL0V1dc4gmzGPkKT3hAcfwI6H2nhW2srzG9q1nYZ1g3cyuK0Yrs4TSDzeiq_R2HHg]

[Blocked Image: https://lh4.googleusercontent.com/wOI40bBmIlmDCq1p3ZONjtK2aPOqKfyXE6-FDxNzl1SpiMz9J0iwZkfQQIiC6XxVOfg5bCoZ4-JVEPAmPp0SC3k1Ww]

year 2009

60ft=2,530

330ft=6,695

660ft=10,214

990ft=13,267

1/4mile=15,867

83,89mph

Today

60ft=2,566

330ft=6,818

660ft=10,337

990ft=13,346

1/4mile=15,848

89,48mph

I change new vacuum diaphragm and now the secondaries open full..I open secondarys today and check if there is fuel inside.

I open secondary and take diaphragm off. is it ok?There come fuel out the secondary box when i open it?!

Edited by - seisei on 07/19/2011 05:05:37

Do you mean this spring set?

http://www.holley.com/20-13.asp

i put ridgid see snake heater hose hole to engine bay. And then i go test drive and follow secondaries what happen when i put gas pedal on the floor.Secondaries only open 1/3 ! What could be wrong?

i took off new replacement coil and put old yellow top coil. car changed totally after the change.Now feels like i need headrest when i put pedal on the floor.But what happen when secondaries open full (3/3)...

i go next saturday drive 1/4 mile and would be nice that secondaries working right..

My car total advance was 48 degrees BTDC ! .Now it is 36 degrees and feels like that i get more horsepower.I don't know what is the best advance..Next i change points and let's see what happen..

I have plans to change my K´s colour to Silver frost in few years to come.I all ready have the colour but I don't know how long it's useable.I got it from previous owner.Only problem is where i can found good painter.

Yes, I'am member of the Mustangclub of Finland.I have been in few mustangclub meetings in this year.

Hi Bo,

Where is your 67 shelby now?Is it here?

Hi

Here is my k-code.It's only one registered k-code in finland.Original colour is silver frost.Car is made in San Jose and it's not GT.

[Blocked Image: http://lh6.ggpht.com/_qxPp-77eZaE/Snnq9wdtXKI/AAAAAAAAABs/WA6AMzb0rDw/s720/musse.jpg]

[Blocked Image: http://lh4.ggpht.com/_qxPp-77eZaE/Snnz7_B7u8I/AAAAAAAAACM/uKgbah49klM/s640/P8010493.JPG]

[Blocked Image: http://lh5.ggpht.com/_qxPp-77eZaE/Snnz9vsVrqI/AAAAAAAAACU/3HHLa0fAv3c/s640/P8010494.JPG]

[Blocked Image: http://lh6.ggpht.com/_qxPp-77eZaE/Snn0b20xkpI/AAAAAAAAACY/SD6CE1DHfB8/s640/Tilannekuva%202008-06-10%2021-54-07.jpg]

Here is my mats

[Blocked Image: http://lh5.ggpht.com/_qxPp-77eZaE/Snnq746UvaI/AAAAAAAAABc/BZ89xj2D9SQ/s512/P8050499.JPG]

[Blocked Image: http://lh5.ggpht.com/_qxPp-77eZaE/Snnq8oZlPBI/AAAAAAAAABk/1ky6ProiCJs/s512/P8050496.JPG]

[Blocked Image: http://lh3.ggpht.com/_qxPp-77eZaE/Snnq9BMFrGI/AAAAAAAAABo/vCxikv2E8L4/s640/P8050497.JPG]

Edited by - seisei on 08/05/2009 15:38:59

My mustang front floor mats have horsehead figure and mustangsunlimited and virginiaclassicmustang sell floor mats with running horse figure.Which mat type is original?

Here is link to my 1/4 mile

Edited by - seisei on 07/19/2009 14:56:43

83,89 mph was end speed.

Sometimes i feel the peak in 3500rpm, but i'm not sure that did it come this time.

the best start:

60ft=2,530

330ft=6,695

660ft=10,214

990ft=13,267

1/4mile=15,867

I change gear on 4500rpm, feels like car is moving better in 3000 - 4000rpm.

Edited by - seisei on 07/14/2009 08:55:51

Edited by - seisei on 07/14/2009 09:02:59

Edited by - seisei on 07/14/2009 09:46:33

I'm going to next weekend to ford nationals days in Alastaro.Let's see if mustang goes under 15 seconds.I try to get soft start with clutch.

is 5000rpm good time to change next gear?

can someone tell me how to make stop the hurst shifters rattle?

hi

I'm going to Alastaro to test my K-code performance and i need some tips how to get fast start with manual transmission without breaking anything?